Get a quote

Drain Fall and Gradient Calculator

Work out how much fall a drain pipe needs over its length, or check the gradient of an existing run.

Grey PVC drain pipe laid in a trench with a spirit level resting on it

Drains need enough slope for water to carry solids away, but not so much that water outruns the solids and leaves them behind. Enter the length of the pipe run and the gradient you are working to, and the calculator gives the total fall and the fall per metre. Measure the actual fall of an existing run to check it.

Drain Fall Calculator

m
mmDifference in invert level between the two ends. Leave at 0 to skip.

Fall needed

Total fall over 12.0 m200 mm

Fall per metre
16.7 mm/m
Gradient as a percentage
1.67%
Gradient as an angle
0.95°

Typical drain gradients

PipeGradient often usedFall per metre
40–50 mm waste pipes from basins, baths and sinks1:40 to 1:5020–25 mm
100/110 mm soil drain from a house1:40 to 1:6017–25 mm
Longer 110 mm drains with good flow1:60 to 1:10010–17 mm
150 mm and larger drains1:100 to 1:2005–10 mm

These are common working figures, not a substitute for the design. Drainage in South Africa must comply with SANS 10400-P and SANS 10252-2 and your municipality's by-laws, which set minimum sizes and gradients and require inspection eyes and access at bends and junctions. A plumber or drainage engineer designs to those.

Measuring fall on site

Fall is measured on the invert, the inside bottom of the pipe. On short runs a spirit level and a straightedge work; over longer runs use a laser level or a water level, and check at each joint so the pipe does not dip and form a belly where solids settle. A drain that keeps blocking in the same place often has a belly or too little fall.

Frequently asked questions

Can a drain have too much fall?
Yes. On a very steep pipe, water runs ahead of solids and leaves them stranded, which leads to blockages. Where a site drops sharply, plumbers use a steeper section with a vertical drop or backdrop at a manhole rather than one long steep pipe.
What does 1:60 mean?
One unit of drop for every 60 units of length: about 17 mm of fall for every metre of pipe, or 167 mm over a 10 metre run.

Get a free quote

Use the result in your quote request and a plumber or supplier in your area can price the job accurately. These services are related to this calculator:

More plumbing tools

Get a free quote